Analog Transmission Systems  (753)

HD-SDI Video inputs(1080p or 720p). 2HD-SDI Video Output(1080p or 720p. Requirement for coaxial cable : L-5CFB Type Impedance : 75 Ohm. Extended distance: Approximately 100M. HD-SDI Video loss LED display

Rack Card Dual video Receiver with Automatic Gain Control Option receives two channels of high quality video on two multimode optical fibers. Designed to be completely tranparent to all camera and monitor manufacturers. I/O level is 1Vpp. 850nm Optical wavelength.

1 channels, 2, 34 x 236 x 152, 1.8 W, 12 V DC

Preferably unshielded twisted-pair cables should be used for the signal transmission.  Are there already existing shielded cables which have to be used, the shield must only be earthed on one end, e. g. on transmitter side.  The best result will be achieved by using cables with a twist of up to 7-times per meter.  Shielded cables, cables with different wire diam., or a connection via patch fields, can considerably reduce the max. possible transmission length.

Transmits single direction audio on one multimode optical fiber at 850nm. Has the option for 1300nm multimode or single mode optics.

The BreezeMAX Base Station consists of two units Indoor Unit (IDU) and Outdoor Access Unit (ODU). The IDU is the main chassis of the BreezeMAX base station, which establishes wireless network connections and manages bandwidth in compliance with the IEEE 802.16e-2005 wireless standard. The IDU is designed for diversity, provides high throughput and is built according to the Software Defined Radio (SDR) approach.The IDU is comprised of two main units in addition to power and management components Access Unit (AU) and Network Processing Unit (NPU). A high-power remote radio unit that connects to an external antenna, the ODU provides high system gain and interference robustness utilising high ransmit power and low noise figure.

Video and alarm system. For visual alarm verification and surveillance via ISDN, GSM, PSTN. Integrated ringbuffer for local recording. Options: full duplex audio transmission.

Genie’s VDS2200 consists of sender and viewer unit and has LED indicators on both units to display status. It also offers real-time transmission up to 500 metres.

Single source module transmitter multiplexes up to 8 channels of TTL and/or dry contact closure on one multimode optical fiber. A set of 8 LEDs on the transmitter and the receiver units indicated the channels in use.

Rack Card Dual video Receiver with Manual Gain Control Option receives two channels of high quality video on two multimode optical fibers. Designed to be completely tranparent to all camera and monitor manufacturers. I/O level is 1Vpp. 850nm Optical wavelength.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

Genie’s VDS2200 consists of sender and viewer unit and has LED indicators on both units to display status. It also offers real-time transmission up to 500 metres.

Signal source Rack card receiver multiplexes up to 8 channels of TTL and/or dry contact closure on one multimode optical fiber. A set of 8 LEDs on the transmitter and the receiver units indicated the channels in use.

Signal source Rack card receiver multiplexes up to 8 channels of TTL and/or dry contact closure on one multimode optical fiber. A set of 8 LEDs on the transmitter and the receiver units indicated the channels in use.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

Transmits and receives 3 channels of high quality video or three multimode optical fibers using FM transmission. Designed to be completely transparent to all camera and monitor manufacturers.

The 07 Series transmits and receives TTL data on dual multimode optical fiber. Designed for continuous long range interference free data.Up to 19.2Kbps Data Range with a 5 pin screw terminal Data connector. 18dB @ 1300nm Singlemode wavelength.

Transceiver with full duplex RS-422/485, RS-232 and audio over one or two fibres.  Modular design in compact form.  Dual fibre audio data multiplexer.  850 nm wavelength with 15dB budget.  Rack mount housing.

The Dedicated Micros DV-IP ATM Express has a compact form which makes it ideal for installing in confined spaces and can be used as a rapid deployment video server for cover or short term security.

The VTP-U video transmission pair provides a cost effective solution for sending good quality video pictures over coax cable. The units have simple controls. The VTP-U consists of BH152 as video sender unit and BH153 as video receiver unit. Both units have built-in surge protection.

ComNet FVT412S1 video transmitter / data transceiver transmits four channels of real-time colour video utilising state-of-the-art digital encoding for high-quality video transmission, along with two channels of bi-directional data, and one-directional contact closure over one single mode optical fibre. The FVT412S1 is compatible with NTSC, PAL and SECAM CCTV camera systems and supports RS232, 422 and 485 (2 & 4 Wire) data. Bi-Color LED indicators are provided to indicate the critical operating parameters.

The 07 Series transmits and receives TTL data on dual multimode optical fiber. Designed for continuous long range interference free data.Up to 19.2Kbps Data Range with a 5 pin screw terminal Data connector. 18dB @ 1300nm multimode wavelength.

The VTP-B video transmission pair provides a cost effective solution for sending good quality video pictures over twisted pair cable. The units have simple controls. The VTP-B consists of BH150 as video sender unit and BH151 as video receiver unit. Both units have built-in surge protection.

Video Modem System, Transmits 1 x Composite Video Signal, 1 x Alarm Signal, 1 x Audio Signal,1 x RS485 Telemetry Signal and 12V DC Power (Max. Output 1A) Over a Single Coaxial Cable.Kit Includes 1 x Sender Unit, 1 x Receiver Unit and a PSU.

BreezeMAX 2300/2500/3500 is a future-proof solution that offers operators reliability, flexibility and compelling economics, while migrating their networks to a standard WiMAX 802.16e architecture. Powered by Intel's WiMAX chipset, BreezeMAX 2300/2500/3500 meets the requirements of a myriad of service environments, from sparsely populated rural areas to high-density urban areas with fast access at net data rates of up to 25 Mbps over a 10 MHz channel. BreezeMAX 2300/2500/3500 delivers broadband access services to a wide range of customers, including residential, multi-tenant, SOHO, SME, and large enterprise customers. 

Outdoor wireless access point, bridge and repeater.  Resolves hidden node and quality of service issues.  Automated configuration, health monitoring and diagnostics with Nextiva.

The ComNet™ FVT/FVR109A series is a video transmitter/receiver and data transceiver that supports the simultaneous transmission of short haul quality 10-bit EIA RS-250C digitally encoded video and bi-directional data over one multimode or single mode optical fibre. The module is universally compatible with major CCTV camera manufacturers and supports RS232, RS422 and 2 or 4-wire RS485 data interfaces and most data protocols.

The Pico is the smallest optical video transmitter in the VBS 2000 series. The Pico can be plugged straight onto the camera's video output. The optional Pico video adapter cord may serve to mount the Pico somewhere else than straight onto the camera.

The ComNet CNFE2DOE2 allows any combination of two RS-232, RS-422, or 2 or 4-wire RS-485 serial data circuits to be inserted onto any 10/100 Mbps Ethernet-based network.

Genie’s “Smart Cabling” passive Baluns are designed for use with Category 5e Unshielded Twisted Pair (UTP) cable. UTP cable is more flexible than traditional coaxial cable, is lower cost and has better transmission qualities. Passive baluns do not require any power source and match the 75 impedance of coaxial cable to the 100 impedance of UTP cable. Passive Baluns can transmit and receive full motion composite video signals up to 300 metres in Colour and 600 metres in Monochrome.

ComNet FVT/FVR200D8S1 is a video transmitter/data transceiver and video receiver/data transceiver series that utilise 10-bit digital encoding and decoding for high-quality video transmission. It exceeds the requirements of EIA RS-250C for short-haul video transmission. It provides transmission of 20 independent video channels and eight bi-directional data channels over one optical fiber and are ideal for use in unconditioned roadside or out-of-plant installations. It has a plug-and-play design ensures ease of installation and no electrical or optical adjustments are ever required. Its bi-colour (Red/Green) LED indicators are provided for rapidly ascertaining equipment operating status.

Rack card Receiver. Receives high quality simultaneous bi-directional sensornet data on one multimode optical fiber.

Transmits high quality simultaneous bi-directional sensornet data on one multimode optical fiber.

Module Receiver. Receives high quality simultaneous bi-directional sensornet data on one multimode optical fiber.

Send an IP Video Signal over Existing Coaxial Cable. Passive System – No Power Required. Exceeds the IEE802.3 10BaseT NEXT (Near End Crosstalk) Specification, Isolates the Receiver from the Transmitted Signal. Transmission up to 100 Metres (Max). Two Pieces per Kit.

The VDS 2200 series offers a range of low-cost fibre optic video-data transceivers. Built-in AGC allows for plug and play installation and maintenance-free operation.  The VDS transmitters come in stand-alone housings; the receivers are rack-mountable or stand-alone models. The VDS system is available in single as well as dual multimode versions and also as a dual single-mode system.  Its bi-directional data interface makes the VDS compatible with all types of cameras (RS-485, TTY, Manchester, biphase, etc).

Rack card Transmitter. Transmits high quality simultaneous bi-directional sensornet data on one multimode optical fiber.